2 ton hand chain hoist hooks and hanging points

The hanging position of the 2-ton inverted chain hoist must meet the requirements of being safe, stable, not easy to fall off, and able to carry the required weight normally. Since manual hoisting machinery is mostly used outdoors, the lifting points are often not like those in the workshop. The beams are fixed and you need to build them yourself or find a suitable location as a hanging point.

Therefore, in response to this situation, in order to enable the hand chain hoist hooks to meet different hanging positions and increase the installation range, the upper and lower hooks of the new VL hand chain hoist are designed with large openings. The purpose is to be able to It is convenient to hook more different lifting points, and avoids that the space inside the hook is small and cannot be hung, or even if it is hung, the hook is full, which affects the actual use and the hook is easily damaged. At the same time, in order to avoid deformation or wear of the hook, it is not easy for users to have a standard to judge the extent to which it is scrapped or can no longer be used. Three positioning points are specially set up on the lifting hook. Measuring the distance between them can be very simple. to determine the amount of deformation.

We all say that the scrap standards for lifting slings require that if the amount of wear or deformation exceeds 10% of the original size or size, it cannot be used, but we do not consider that it is difficult for users to calculate this data. The errors in measurement will also vary, so it cannot be judged accurately. The role of these three anchor points can effectively meet actual needs and is more feasible.